Plus 2.X:Zones

In WUFI®plu a building is created and then calculated. Therefore you generate a simulation volume i.e. the room volume of the building for which further necessary information must be entered using zones.

In general there are two kinds of zones:

• Heated Zones belong to the simulation volume. Under the zone entry in the Tree specifications can be made.

• Attached Zones are all areas that do not belong to the simulation volume, for example an unheated attic. They influence, however, the conditions in the simulation area and must be precisely defined. To modify these attached zones click on their zone entry in the Tree.

Of course these zones and climates must be assigned to components of the building

Assigning zones and climates to components

Each Component has got a inner and outer side. This is defined by the normal vector of the component which always points out of the outer side of a component. Right clicking on a component in the Visualization Box allows changing the orientation of it.. So a component always has a inner and a outer side and needs to have a zone or climate attached to each. This "inner-outer side" nomenclature is of course reasonable for exterior walls, the outer air (=the outer climate) must be assigned to their outer side, and an appropriate zone to their inner. However for interior walls the "outer" and "inner" wall nomenclature is only a way to distinguish between the two sides and the possibly different zones attached to it. Again orientation and correct attachment can (and should) be checked using the normal vector.

New zones can be created optionally using the zones button in the Visualization Box. Creation of new zones can be highly useful, as mostly there aren't the same conditions in every part of a building.

Assigning zones to a component is either possible under the component's entry in the Navigation Tree under section "General" or by right clicking on the respective component in the Visualization Box and then choosing Properties.

The different zones and the components allotted to them appear in the Navigation Tree with all the components assigned to them. Although a component has always got two zones assigned to it, one on the inner and one on the outer side it "belongs" to the zone that was apportioned to its inner side in the Navigation Tree.