Plus 2.X:Zones

 überarbeiten! reihenfolge!!!

A component always has a inner and outer side and needs to have a zone or climate attached to each side of it.

• optional climate
• main outer climate
• heated zone
• attached zones

Each Component has got a inner and outer side. The normal vector of a component always points out of the outer side of a component. Right clicking on a component in the Visualization Box allows changing the orientation of it.

This is of course reasonable for exterior walls, the outer air (=zone with outer climate) is assigned to their outer side, and a appropriate zone to their inner. However for interior walls the "outer" and "inner" wall nomenclature is only a way to distinguish between the two sides and the possibly different zones attached to it. Again orientation and correct attachment can be checked using the normal vector.

Assigning zones to a component is either possible under the component's entry in the Navigation Tree under section [Plus 2.X:Visualized_Components#General|"General"]] or by right clicking on the respective component in the Visualization Box and then choosing Properties.

The different zones and the components allotted to them appear in the Navigation Tree with all the components assigned to them. Although a component has always got two zones assigned to it, one on the NV!!!!inner and one on the outer it "belongs" to the zone that was apportioned to its inside in the Navigation Tree.