Discussion:Main

Please make sure, that the user is NOT the problem. After that proceed with the following:

WUFI 1D Pro

hmm...

WUFI 2D

haa...

WUFI-Plus

Bugs

• Two graphs are shown on one page. If the date-axis is changed on the above graph, the second graph is then different - but only one x-axis label is available.
• Sometimes window can not be minimized

Problems

• By use of "Assign from Database" the setup is overridden without asking (asking happens only if "Edit" is used.
• How do I create a monopitch roof?
• Is the A/V ratio based on the internal or the external dimensions?
• How is the exterior climate data interpolated with shorter timesteps than available in the climate file? How big is the difference of simulations with hourly values and shorter timesteps?
• How are the ventilation control mechanisms exactly?
• How do I model groundwater? (I can only specify 100% RH but no fluid water on the surface)

Wishlist

• Time-dependent shading
• Specified saving options (without results, with general results, with results for each component) on one page, not seperately for each component
• Calculation results: Please add surface area in the component information part
• Differentiation between forced and natural air exchange (with possibility to read file)
• Preview of the created building in the building wizard
• Define standard dimensions of windows with frame reduction factor and adapt frame reduction factor with changing window dimensions
• Start "Calc Wufi" from header-dialog
• Delete "new case" button
• Give choice if one wants to copy windows for every storey in a multi-storey building
• Batch mode for WUFI Plus with automatic results file generation
• Possibility to read each boundary condition from file
• Save project without results

Christoph's annotation

Smaller Problems

• Distribution of solar gains on inner surfaces

If Other_Parameters "Proportional to area", 100% of solar gains will distributed proportional to the components, or 100% less "Solar radiation direct to inner Air"?

In the case of "Proportional to area" in Components -> Numerics "Solar radiation on inner surfaces[%]" shows the percentage [1...100] in an inactive box. But if "user defined" you must not input a number between [1...100], but between [0...1].